Getting your Rear car window replacement done is not that difficult. You will just need a few tools and the novel parts but the work isn’t complicated if you are patient. The very first step is to get rid of the upholstery on the inside of the boot door. Most handles are screwed into place and have to be removed.
After the handle is removed, the next step is to remove the bottom of the door panel. You can get hold of special tools for this but most people make use of a screwdriver. Gently pry along the edge of the panel till the fasteners pop out. The door panel fasteners have the shape of a Christmas tree with the base properly attached to the boot door. These fasteners are located about every 3 or 4 inches.
The next step involved in your Rear car window replacement cleaning the window track and guide. Get rid of the old window seat and other parts of the old window. Looking at the novel window somewhere along the rear edge near the top, there is typically a small hole drilled through the glass. The purpose of the hole is to put a small plastic piece which snaps into the hole. The plastic piece smoothly rides in a track at the back of the window opening that keeps the rear window straight in the door. Some models need this to be installed before putting the window in. Slide the novel window glass in very carefully. Remember, even a tap on the edge of the glass can break it.
Check properly the operation of the window before you put the door back. To replace the door panel you have to make sure that you line up all the fasteners before you attach any of them. Reattach the boot door handle and your Rear car window replacement is done!
No comments:
Post a Comment